Seagull #IMU – let’s get it running !
Below you will find support for Seagull #IMU. These sections only cover basic parts from the full manual !
Click on a subject below …
Use the cable with BLUE SLEEVE to interface with Seagull products such as #MAP-X2.
Once #IMU has been plugged into the #MAP-X2 – you will need to enable the #IMU and calibrate it via #MAP-X2 config executable. When it has been enabled and calibrated – you do not need to repeat calibration process, as the offsets are saved within #MAP-X2.
Magnetometer
Hold the sensor parallel to the ground and perform figure 8 pattern as shown in the illustration below:
Once the magnetometer is fully calibrated the bar on the #MAP-X2 config will be full green.
Accelerometer
Place the #IMU in all of the six position as illustrated and hold it for few seconds in each of the positions.
Once the accelerometer is fully calibrated the bar on the config will be full green.
Gyroscope
Simply place it in any stable position for few seconds until the GYRO value on the config bar is full green.
