Seagull #MAP-X2 – let’s get it running!

Below you will find #MAP-X2 Support.  These sections only cover basic parts from the full manual !

ArrowDownNEW  Click on a subject below …

Setting up Seagull #MAP-X2 could not be easier! Simply select the channel that the device is plugged into and trim the LOW/HIGH values for that channel, until desired modes are met – refer to the table below:

Connect the servo cables by following the polarity markings on Seagull #MAP-X2 and connect the other end of servo cable to your Receiver / Flight Controller, with the correct polarity.

Please refer to the manual of your specific R/C radio system or Flight Controller to find out more about how to connect accessories and what ports to utilize.

NOTE: for Pixhawk users – #MAP-X2 can be powered by Pixhawks power rail ( the middle pin + ).  Ensure that the rail is powered by BEC or other power source ranging from 3.9-12 volts  in order for Seagull #MAP-X to function properly.

Receiver

Pixhawk

DJI A3

Mission Planner

Start Mission Planner and follow the steps below.

Click on INITIAL SETUP >> OPTIONAL HARDWARE >> CAMERA GIMBAL

“SHUTTER” – in the drop down list, chose the channel that Seagull #MAP-X2 is connected to.

“PUSHED” – Set the “Value” for the AC-T mode

“NOT PUSHED” – Set the value “1500” ( Neutral state – see table above )

“DURATION” – Set the value “1” for AC-T mode

(Value may vary depending on the cameras’ speed to lock focus, make sure that you have correct settings on the camera side and if running camera with slow focusing lenses, increase the camera focus time through MAP-X2-CONFIG)

 

Example from Mission Planner:

DJI Assistant

Setting up could not be easier – simply choose the F port that the #MAP-X2 is connected to and configure it as a Shutter. Then in the “SHUTTER” tab adjust the settings as in the picture below!

To determine what Seagull #MAP-X2 is currently doing – simply read the output of the “X STATE” and “SD CARD” LED, then match it with the “Action” in the table below.

Still in doubt ?

Fly to our Contact page with your question
– and we will get back to you ASAP !