Supported Sony models
A77 (mk2) – not mk1 !
A7 (mk1, mk2)
A7R (mk1, mk2)
A7S (mk1, mk2)
RX1R (mk2) – not mk1 !
RX10 (mk1, mk2, mk3)
RX100 (mk2, mk3, mk4, mk5) – not mk1 !
NEX-3N (no other NEX model supported !)
#REC – capture the moment !
The most affordable and feature rich Sony MULTI camera controller on the market !!
Capture the moment with Seagull #REC for Sony MULTI equipped cameras ! Don’t miss out on those beautiful moments, landscapes and the action !
#REC gives you the utmost control of your camera whilst in flight ! – control #REC either by your R/C transmitter from the ground or let the tasks to be completed by Ground Control software/Mission planner.
Seagull #REC is a “Plug & Play” solution and comes with all the accessories necessary to get you going and start capturing aerial footage !
#REC controls the following functions on your camera:
• Video record start/stop
• 2 Auto Photo modes
• Manual Photo mode
• Camera On/Off
Videos of Seagull #REC:
We now offer our newly developed cable for #REC !
We learned that the standard cable for #REC was a bit hard on gimbals – especially low-powered ones.
… we listened to you guys – and are proud to present our new ULTRAFLEX cables !
ULTRAFLEX is as the name states – ultra flexible, and is the ultimate in flexible cable design – perfect for your video gimbal setup !
The new ULTRAFLEX cables have a cable outerdiameter of only 2.5mm – that’s 2mm less than the Standard cables, we even managed to shrink the size of the MULTI connector ! ( see comparing photos above )
#REC – controls at Your fingertips !
#REC is designed to work with the latest Sony’s cameras that are equipped with the MULTI interface ( Multiport / Multiterminal ).
It’s a perfect solution if you are working within Aerial Videography where you need capabilities as Zoom, auto-focusing while recording etc. but will also suit you when doing Photography, Geomapping, Agriculture Analysis, 3D modelling or similar fields where you need utmost control of your camera.
#REC is controlled by a standard PWM servo signal from your R/C receiver and/or Flight Controllers like 3DR Pixhawk, APM 2.6, DJI Wookong, DJI A2, A3 – and many others with camera support.
What is does
Seagull #REC support the following functions
• Video record Start/Stop
• Zoom ( 7 speeds in each direction – W/T )
• Autofocus Trigger ‘AF-T’ ( 1 sec pre-autofocus – then trigger )
• Instant Trigger ‘IS-T’ ( instant trigger – as soon as camera locks focus )
• Manual Photo mode ( 2-stage individual focus and trigger )
• Camera On/Off
• Timelapse ( Intervals: 1, 2, 3, 4, 5, 10, 15, 20sec )
What it supports
The following hardware is supported
• Flight Controllers: 3DR Pixhawk, APM 2.6, DJI Wookong, DJI A2 – and many others with camera support.
• All R/C radio systems that interfaces with standard PWM signal (almost any radio system)
Watch the Videos on the Support page
What you get
The following is part of this product
1 x Seagull #REC
4 x Servo cables ( 20cm length )
And off course – all the support your could wish for !
What it is
Details for this product
• Dimensions: 41.2 x 17.5 x 6.2 mm ( L x W x H )
• Camera cable length: 30cm or 60cm ( depends on choice when adding to cart )
• Weight: 3.8g ( ~16g with 30cm cable / ~22g with 60cm cable )
• Voltage: Powered by camera ( *optionally powered by the input rails – min. 3.8V – 16V max ! )
• Current: 60mA max
• Input signal: Standard R/C PWM servo signal ( between 1000 – 2000uS )